Jual Emlid Navio 2 di Makassar | Indosurta

click to zoom

Harga	Hubungi Kami @   Navio2 board Turn your Raspberry Pi® into a drone controller by using the might of sensors and controllers on board GNSS re...
Kategori	Produk
Share	. . . .
Hubungi Kami
	BELI

Review Jual Emlid Navio 2 di Makassar | Indosurta

Hubungi Kami @

 

Navio2 board
Turn your Raspberry Pi® into a drone controller by using the might of sensors and controllers on board

GNSS receiver

Tracks GPS, GLONASS, Beidou, Galileo and SBAS satellites. External antenna with MCX connector

RC I/O co-processor

Accepts PPM/SBUS input and provides 14 PWM output channels for motors and servos

Dual IMU

Accelerometers, gyroscopes and magnetometers for orientation and motion sensing

Triple redundant power supply

With overvoltage protection and power module port for voltage and current sensing

Extension ports

Exposed ADC, I2C and UART interfaces for sensors and radios

High resolution barometer

Senses altitude with 10 cm resolution

Preconfigured OS image

This is a Raspbian you know with ArduPilot and ROS preinstalled and ready to run with a couple of simple commands. Also comes with DroneKit and GStreamer.

Most advanced and full-featured open-source autopilot software. With Navio2 its code is executed directly on Raspberry Pi with preemptive Linux kernel.

6 supported vehicles

Copter, plane, rover, boat, heli and sub

Advanced flight modes

Auto, follow me, guided and others

Waypoint navigation

Full control of missions with multi-platform GCS

A collection of software frameworks for robot software development, providing operating system-like functionality on a heterogeneous computer cluster.

 

Program missions

Use ROS or DroneKit to make your drone perform preprogrammed actions and respond to changing conditions.

Control over the Internet

Plug in 3G/LTE modem to connect to your drone from anywhere in the world and access video and telemetry data.

Stream video

Transfer low-latency video from Raspberry Pi camera module to the ground control station using GStreamer.

 

Awesome Navio2 projects from our users

Share your project or ask any question on our community forum to get advice from experienced users and Emlid team.

 

Waterproof quadcopter

Land over water with built-in line drop system working with a servo. The project is selected in the Guardian's favourite projects of 2016.

Specifications

Mechanical

• Dimensions 55x65 mm
• Weight 23 g
• Operating tº -40…+85 ºC

Electrical

• Supply voltage 4.75-5.25 V
• Power supply Power module, servo rail, USB
• Average current consumption 150 mA

Ports

• Power module
• UART
• I2C
• ADC
• 12 PWM servo outputs
• PPM/S.Bus input

ICs

• MPU9250 9DOF IMU
• LSM9DS1 9DOF IMU
• MS5611 barometer
• U-blox M8N GLONASS/GPS/Beidou (antenna connector type MCX)
• Cortex-M3 RC I/O co-processor
• RGB LED

Baca  juga ini: Metode Pengukuran Horizontal - Poligon